combo laser plumb bob dot horizontal vertical lines

I can project a horizontal line on a wall then measure to find high and low spots on a floor. Using the vertical line, I can mark where wall studs are located, making it easy to place screws when hanging cabinets. About 90% of my work is done without any assistance and I am always looking for ways to operate easier and faster. The Klein Tools Laser Level, Self-Leveling Green Cross-Line and Red Plumb Spot is a true asset to my job. That said, it's a minor inconvenience that can be corrected on the first use, still a home run. I suggest writing it on the side of the unit in sharpee after you figure it out to prevent future headaches. The nail hanger does leave a little to be desired, you have to figure out how far below the nail hole the line appears and then add that to your measurement. It has some ability to rotate on it's base, and the base can be hung from a nail, so you have a little flexibility when finding a spot for it. You can choose a spot (dot), horizontal line, vertical line, or both lines (a cross). There is a little bobbing and shaking after you set it down until the beam situates itself, but once it's there it's totally accurate. This works like all cross lasers I have ever had, the laser beams 'float' on a liquid of some kind. I have a similar laser in red and the green is just hands down easier to see. Why did they ever start with red lasers? Green is the new gold standard. This is a great tool for construction work. Cut the distance in half and the light is four time brighter. However, this can be overcome by moving the laser closer to the work area. The brighter it is the harder it is to see the laser lines. The case the laser comes in is well designed to carry the laser, mounting bracket and the instruction booklet.Īs with all of the lasers that I have ever used ambient light is not your friend. One of the features that I really like is, once the laser is set up, it can rotate 180 degrees so you can move the vertical line where you need it without remounting the laser. The mounting bracket has a keyhole so you can put a deck screw into a post and hang the mounting bracket and then the magnets on the laser connect it to the mounting bracket. You can mount the laser on a tripod as easy as you can a camera or you can use the mounting bracket. I tested the ‘out of level light’ (pictured) to see if came on when I was beyond the 4% and it worked. It only has to be within 4% of level and it will do the rest. Making sure the level is level has always been a challenge for me at a work site and the automatic leveling feature eliminates a lot of that work. This Laser Level has some really nice features: Automatic leveling, versatile mounting bracket, and the ability for the tool to rotate on its base are a few.

Combo laser plumb bob dot horizontal vertical lines